Thanks
Many thanks JohnZ....I missed the screw driver slot on the bolt but loosened the lock nut (it was actually a bit loose as is) and turned the bolt as you suggested......will give it a test next week and will continue to adjust if needed.
:v My left and right hand hood latches appear to grip correctly when the hood is closed......they unlatch properly too when the hood handle is pulled. However, when the hood is closed the RH latch releases (or looses its grasp) after driving the car and hitting a bump or two. The LH latch...
:eyeroleThe oil pressure gauge on my '67 reads to about 15psi after the car starts and stays exactly at that level no matter what the revs, temp, etc are. Oil level is correct, no overheating, etc. The car grew up in Florida and has an oil cooler installed. Is there some kind of "sending...
Yes, the voltage regulator is a Delco unit mounted on the inside drivers side fender well. I understand these may have date codes but I couldn't find them. Am taking the car over to my Vette specialist for exhaust replacement and will have him check out the alternator and voltage regulator...
:ugh I have noticed that while my '67 air coupe (base engine) is running, the interior lights will flicker with a frequency tied to engine revs....the faster the revs the faster the flicker. The ammeter indicator arm also fluctuates with the revs speed in time with the light flickers. The...
I received my NCRS "Shipping Data Report" for my '67 coupe which was shipped to the dealer noted above in February, 1967. A Google search for this dealer turned up very few references to the dealership on a Rogers Street in Lowell, Mass. I did find a Lannan Chevrolet of Lowell (located on...
Thanks, I have seen a "factory" picture of a '63 with the decal on the rear window, passenger side bottom towards the rear. The parts vendors have the decals from '63 through '66, but not '67. BobC
Does anyone know if the '67 Corvette with A/C had a window decal "air conditioned".......if so, where should it be located on the car. Thanks in advance as usual. BobC, Cincinnati, Oh
'67 Coupe Jacking Instructions
I know where the jack is but there are no instructions in either bin. Does the decal go on the botom or side of either storage bin. Thanks, BobC
:happyanim:While looking over a Corvette parts catalog, I came accross a decal for jacking instructions. Where does this decal go on the car? Thanks as usual! BobC/Cincinnati
:w My "new" '67 coupe (base engine) has 205/70 radial tires on the stock rally rims. Can I put 205/60s or 225/60s on the car without turning/fender scraping problems? Many thanks, Bob Carroll, Cincy, Ohio
I did pull the carpeting and the hooks (anchors) are there!!!!! I emailed Corvette Salvage (Picayune, MS) and they are sending me the correct tie-down strap! Thanks to all for your help! Bob Carroll:beer
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.