Welcome to the Corvette Forums at the Corvette Action Center!

Search results

  1. C

    Noise at Rear Wheel on '71

    Just my 2 cents worth,you might see if maybe the right rear brake caliper might be giving you some trouble.Maybe the pistons in the caliper could be hangin up because of corrosion in the cylinders,I know the sound you heard,I have had it happen to me on one of mine.It sounds like the brake...
  2. C

    Question: Flex Plate Replacement -- do able?? Anyone done it??

    Just my 2 cents worth,I had an old truck with a bad flexplate but couldn't find anybody to replace it for me.I read somewhere about a neat trick,get about 4 pieces of all-thread the same size of the bolts that hold the trans to the engine and replace the bolts with the all-thread as you take...
  3. C

    Help! Need Honest Opinion and Advice on Torq-Thrust II Wheels

    5x5 is also chevy truck wheel bolt patern and large chevy car,like impala and caprice.
  4. C

    Question: cracks in fiberglass

    I recently traded for a 76 vette,and recently notice that there is two cracks in the fiberglass behind the rear window,one on each side of the insde vertical panels that taper down to the rear deck.Should I drill a hole at the ends of the cracks to keep them from gettin worse or just fill and...
  5. C

    starting issue -mystery

    If you got a hei ignition,sounds like the modual is dead,if you got points,check the gap and the connections on the dist. and coil and coil wire.Wouldn't hurt to check rotter button either.Just a wild guess.Things like this can be a pain.
  6. C

    Suddenly won't start-then it does.

    I had a old chevy truck that was giving me the same grief.So one day I pulled it into the garage with my mind set on finding out what was goin or die tryin!I check all grounds,fuzes,wiring and everything else.I started it up and I took a volt meter and measure the voltage at the alternator,guess...
  7. C

    C3 Power Steering (Electric Pump)

    605 power steering I was thinking about this swap and was wondering if you could use the pump thats on the car and swap in a 605 sector and then add the link in ,like it came with manual steering.The pump pressurizes the steering box sector like on a full size Chevy,only promblem if there is a...
  8. C

    Rocker Panel Moldings

    The cheapest place I found is ebay.I know its a gamble,but I have had good luck.As a matter of fact I bought 2 sets off of ebay couple years ago and they were good for a driver and at a good price.Most ebay people are honest,just tryin to make a living!I hope this helps. Mark
Back
Top Bottom