Welcome to the Corvette Forums at the Corvette Action Center!

Search results

  1. J

    Midyear Hood alignment: a raised front

    Hood Issue Wow, the "correct" solution would be alot of work. Can it be that the car is that far off from the factory? Looking at your hinge photo, I see the bolts for the top and bottom hinge halves do not overlap. I wonder if slicing the bottom of the hinge below the pivot point with a cut...
  2. J

    Midyear Hood alignment: a raised front

    I have a '63 convertible with a hood alignment issue. The front edge of the hood sits about 1/4 inch above the headlight panel. There are no shims to remove under the hinges. The Corvette assembly manual mentions adding shims to raise the front of the hood but no incite on how to lower a high...
  3. J

    1966 convertible for sale

    66 Corvette Is this car still available. i noticed the 67 vents and hood. Is this a 66 or a 67? What kind of body repair was necessary. Thanks!
  4. J

    Question: 1963 Speedometer Cable

    I stand corrected, thanks for the info.
  5. J

    Question: 1963 Speedometer Cable

    You are both correct. I found some casting numbers on the trans, specifically P9R014 which my research indicates a Muncie trans manufactured in October of 1969. It is interesting that the cable is currently routed through the early grommet and does fit but the cable comes quite close to the...
  6. J

    Question: 1963 Speedometer Cable

    This may be a simple question for some but I'm stumped. I have a 1963 Convertible with a fourspeed. The Corvette Assembly Manual and Corvette Shop Manual both show the speedometer cable connected to the driver side of the transmission tailshaft but my cable connects to the passenger side of...
Back
Top Bottom