What Octane do i have to run with a 427 motor .030
Compression is 12:1 will pump gas work like 93 octane????
Thanxs for any help it is a brand new motor i started it up with
Cam 2 fuel right now just trying to see how much is really needed!???????
I am trying to return my vette back the original specs!! did they come with
Firestone tires or Goodyear tires???? i know they where the bias type tire
mine was the white wall kind i just want to make sure i order the right one
or Brand Firestone or Goodyear?????? can someone help???Thanxs
Can i get ya'lls opinion:ugh on my main clearances
on my 427 i bought after market connecting rods as well which will go
to 7500,RPM my rod clearance is .001 as well
On a 427 chevy big block the rear main seal does the > the big end or the opening face the front of the motor and the pointed face the rear???does any body have any pictures????thanxs joe
Can some one help me get on the right track i am trying to
install a set of emergency brakes Stainless steel the problem i am having is
were the parking brake Actuating Lever sits in between the two shoes it is keeping the shoes from touching the Anchor post about a 1/4 of inch what am i doing...
I purchase a Tunnel insulation for my 69 Vette after holding it up in
place there is about 8 inches of spave to the edge of the firewall
i have not be able to figure up what goes in the place of the tunnel
insulation and up to where the back of the motor is????
can some one help me with this...
I went through the NCRS and my letter indicate that
the original delivery dealer was
Dealer code 611 in zone 9
how do you find out how decode this?
thanxs
Im in the process of rebuilding my 427/390 motor, It is a number matching motor
i would like to bore it out 030 over and raise the compression ratio up some maybe
11.0 to 11.5 somewhere in that area! My question is? Will this hurt the value of the
motor/car by doing this ???????
I am in the process of removing my 427 out of the car, to rebuild it! and after being under this car unhooking everything linkage,exhaust driveshaft,ect..... it kinda looks like the motor wont come out with the trans attached? due to the non removel crossmember
or will it? have any body pulled...
Base on my Maincase Casting number ( 3925660 ) from what i have found
this is indicating that my transmission on my 1969 Big block corvette is
a M-22 is there any other why of determining this??? thanxs
I have a 427/390 motor with the 063 heads! im going with a 639 lift roller hyd cam, and i was told that!,The valve guides need to be cut down! why would that be needed??? have anyone ran into
this before?
Thanxs Ricochett
Well i took a peek through my gas cap lid to see if my build sheet was
there but it wasnt! So is there any way i can get a copy of my dealer invoice
and a build sheet??
Thanxs
Hello everybody im new here! i am rebuilding my 1969 corvette 427/390 motor,
after pulling the heads off the motor i notice the valves are white on the exhaust
im concern they might have been ran hot! but im not sure! does anybody have
any reason why the did this?
Thanxs
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.