Hello,
I have a'84 corvette (sincenew, 37K miles) – Last Sat, when starting the car, and turning on the AC, Ifelt the RPM’s fall off, and then the check engine displayed on the dash.
Using atwo pin connector, with the ignition on but the motor not running, I pluggedthe 2 pin connector into...
Hey folks,
Have a an '84 corvette, 35K miles, and my driver side elec window stopped working today. I can hear the motor work, but the window is stuck half open / closed.
Not sure, but sounds like a the 'ribbon cable' broke like so MANY of these cars.
Trying to figure out what my options...
Folks,
In checking Rock Auto, they do not have an 'evaporator' for a 1984, only a evaporator 'repair kit'.
They do have the evaporator for a 1985 - 1989, I called Rock Auto, they were unable to tell me if the evaporator for a 1985 - 1989 would work on my 1984.
So my question is will an...
LLC5,
We checked the AC system, it held the pressure without being A C/ engine turned on.
We used a freon detector, (a wand type of instrument) a sniffer, we checked ALL of the R12 connectors, connections, and NO freon detected.
Then we turned the temp control inside the car to Max, turned on...
I've located some R12 'compatible gas' which is MFG & sold in Canada, it's flamable, but apparently it's twice as effeicent as R12 - meaning you only use 1/2 the amount of the gas, and it's 100% compatible with R12.
and it's cheap.
I was thinking, don't replace the evaporator and perhaps I...
Hello Folks,
Have searched this forum and others, and all I read is, it's not fun . . .
I have a "very" small leak in my R12 freon, (1984) AC system - which has been identified from a freon leak detector coming from the AC evaporator.
So, I am looking for some suggestions, instructions or...
I have a '84 that had high idle, similar to yours, then at trigged an check engine, which as code 21 = throttle position sensor - replaced the TBS, and the car now idles like it should, (700 RPM) and runs SMOOTHLY.
The TBS may be your problem as well.
Hello,
I have a '84, similar problems as yours, I replaced the Throttle Position Sensor (TPS), and immediately solved my problem:
Go To: http://www.corvetteactioncenter.com/forums/c4-technical-performance/134434-1984-throttle-position-sensor-tps-2.html#post1126392
Folks,
Since I've had some excellent comments / results from ya'll, I thought I would ask for a few more suggestions:
1.) I need to replace the upper / lower radiator hoses, I am looking at the Goodyear pre-cut and the Gates cut your own.
Any comments or other suggestions?
2.) Need to...
Folks,
It was bad TPS - installed a new TBS, set it to .525 volts, and even DID NOT have to reset the ECM or disconnect the battery, it automatically cleared the code 21. The new TPS made a huge difference on cold starts and idling.
Again, MANY THANKS to you folks - this is a great forum . . ...
lt1george - thanks, I do value your comments, as I currently running the stock 195* thermostat, and about to replace it, and was "KINDA" thinking of a 180*, after your posts, definately will install a 195*.
No harm, no foul . . .:thumb:thumb
Folks,
As noted in my OP, all comments are welcomed - as I may not have the technical skills to fix cars, I am eager to learn, and listen . . .
And I make mistakes along the way.
I greatly appreciate all of the comments here, as I attempt to isolate and fix car problems as they surface.
But...
It1-george
Thanks for the "heads-up" on the 195* thermostat . . .
The car has 35K miles on it, I bought in 1985, so it's running the original 195* thermostat.
I am planning to replace the thermostat and hoses shortly, so your comments are appreciated.
I too had been thinking about going with...
Hib,
Again, "many" thanks . . .
Do I have to be concerned if I order the Standard Motor Products TBS - as I may have heard bad things about this company?
Also take a look at the 2nd pic I have attached (Throttle Position Sensor-2), as I have highlighted a red arrow to this Metal Step, is this...
Gents - all great posts . . .
Hib, Should I buy an ACDELCO TPS for 2-3X as much as a Standard Motor Products TPS ?
Does the TPS have an O-ring that connects to the throttle body?
In the pic I posted on this post, I highlighted (red) a "metal pedal" located on the TPS, - what's the purpose of...
I have the FSM . . .
If I replace the TPS with a new one, and set the volts at .54 on idle, and 5.0 volts at WOT (per the FSM).
Do I also have to set / adjust the (2) Air Idle Controls (AIC)?
Folks,
Thanks for the replies . . .
As previously stated, I have an 1984, and the Check Engine, code = "21" - in the FSM, it specifically says check the Throttle Position Sensor (TPS).
There were no other codes.
And why do you suggest that it's not my TPS and is my Intact Air Control (IAC)...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.