A wanna hear an L-98 with a hotcam installed?

[SPANISHVETTS]

Sounded good Punch!


i'll have to make a short vid of mine with the 2.59 gears and full bolt on's from a 20 punch on DR's! sometimes it gets hairy even from a 40 roll less cam heads and intake

388 stroker going in soon! picking it up friday i hope

Mad-Mic with a 388... I am glad I am on the other side of the ocean. :W:W
I will buy lunch if you do not get into the mid 11´s. For me the stroker is what the SBC is all about...Ain´t nothing like 450 ftlbs of torque kicking you in the butt at 2000RPM Enjoy it Mic.

 

[Mad-Mic]

hehe you know it

still gonna run some juice

 

[Mad-Mic]

Mad-Mic with a 388... I am glad I am on the other side of the ocean. :W:W
I will buy lunch if you do not get into the mid 11´s. For me the stroker is what the SBC is all about...Ain´t nothing like 450 ftlbs of torque kicking you in the butt at 2000RPM Enjoy it Mic.

i bet i'm close to if not at or over 400 rwtq now and at 300 rwhp. before i do the swap i will dyno the car before i pull the motor. i'm still a few months away before i can do the swap as the car goes into the paint shop next week.

i'm hoping for 400-500 rwhp and same on rwtq with out the shot then add 150 on top of that for the final number

 

[nyernga]

i'm hoping for 400-500 rwhp and same on rwtq with out the shot then add 150 on top of that for the final number

Whats the matter Mic.....Won't Lockheed sell you an F-22 raptor? I mean geeeeeeze.

Len

 

[SPANISHVETTS]

Whats the matter Mic.....Won't Lockheed sell you an F-22 raptor? I mean geeeeeeze.

Len

Compared to a Stroked SBC this is the second best kick in the butt ever built.
0 – 150 MPH in less than 300 Feet.
I might add that the SBC does not require the steam assisted CAT nor does it burn over 300 pounds of fuel per min and therefore substantially less expensive per mile of smile.

 

[WhalePirot]

I might add that the SBC does not require the steam assisted CAT

Really?