Question: Active handling/Traction Control fault

[2010corvette]

Own 2012 Corvette Coupe with MX0 automatic transmission and base axle ratio.
After hard launch my driver information screen displayed "Service active handing & Traction control systems.
The indicator icons lights for both systems stayed on for a few days on the dash and then went out. No DTC's were stored.
Does this happen occasionally on Corvette with it's sophisticated electronics or will I see problem reoccur?

 

[Hib Halverson]

How did you determine no DTCs were stored?

 

[2010corvette]

How did you determine no DTCs were stored?

Vehicle checked for DTC's with Tech 11.

 

[Hib Halverson]

It would be unusual for those service lights to be on for several cycles then go off leaving no history codes.

All I can suggest is that you monitor those systems' performance and if the lights come on again, immediately connect the TECH 2 and read the fault codes. If no codes are set either take the car to the dealer for service or if you are a DIY, consult the factory service manual for what to do when the service light is on but no codes are set.