Welcome to the Corvette Forums at the Corvette Action Center!

Back in 86 ..............

B

Brian86

Guest
Back in 86 Chevrolet decided that in mid year they would change to aluminium heads and go with centerbolt valve covers. Well that was fine,but was the 86E 350 the same as all other 350's before. The big question here is will the intake off of an 86E with the old iron heads fit an older blockand heads(1972).
The engine in question is a 1972 4-bolt main that is .30 over with a little over 9.5 to 1 compression , a .512 inch lift cam and 1.5 roller rockers. I had it dyno'ed at 360hp and 390lbs/ft.
Would it be worth the time to swap all the TPI stuff over to this engine (if it will match up) and drop it in. I know I will need to have a new chip programmed , but would there be anything else.

Brian :confused
 

Corvette Forums

Not a member of the Corvette Action Center?  Join now!  It's free!

Help support the Corvette Action Center!

Supporting Vendors

Dealers:

MacMulkin Chevrolet - The Second Largest Corvette Dealer in the Country!

Advertise with the Corvette Action Center!

Double Your Chances!

Our Partners

Back
Top Bottom