C1 ('62) Rear Axle Gasket & Seals Needed

[rkew]

Does anybody know where I can get my hands on a replacement carrier gasket, axle shaft seals, and a yoke seal for the rear axle on my '62? I didn't have any luck with Mid-America, Eckler's, and NAPA (nothing earlier than '63 for those parts according to the websites I looked at and person I talked to).

Thank you,

Ryan

 

[studiog]

Did you try Corvette Central or Paragon Reproductions?
http://www.corvette-paragon.com/

http://www.parts123.com/PartFrame.a...tecentral.com/menu.htm&TITLE=Corvette_Central

 

[Rowdy1]

I Don't Remember Now But.......

If I'm not mistaken, you can clean the surfaces and use the blue silicone and make your own. Did you try the place I gave you a few times? Corvette Specailty Inc? I sent you a few PM's but you never replied so I wasn't sure.

 

[JohnZ]

Doc Rebuild and Corvette Central both have everything you need.

 

[rkew]

Rowdy1,

Thanks for the info but Corvette Specialty Inc. didn't seem to have what I was looking for, but I didn't go as far as calling. I just looked on the website. I ended up finding everything I needed at Paragon. Thanks again.

Ryan

 

[Rowdy1]

Huh...........

I didn't know they had a website. Glad you got what you needed, I tried.

 

[tsarbar]

The carrier cover can be sealed using only a clean surface and some quality silicone adheasive. As for the axles and pinion seals you local parts house should be a good source for replacement parts..

Good luck on your project.