Welcome to the Corvette Forums at the Corvette Action Center!

Front Suspension Geometry

6

68 427

Guest
I am redesigning the front suspension to increase camber gain, caster and decrease the scrub radius so the car will work better on the street and at open track events. I plan to replace upper control arms and spindles with fabricated parts and I am using a suspension modeling software program to design the new pieces, but I don't have accurate measurements for the factory parts. It is very difficult to measure with ball joints.

Does anyone have the factory dimensions for locating pivot points for spindles, control arms and steering?
 

Corvette Forums

Not a member of the Corvette Action Center?  Join now!  It's free!

Help support the Corvette Action Center!

Supporting Vendors

Dealers:

MacMulkin Chevrolet - The Second Largest Corvette Dealer in the Country!

Parts/Accessories:

Vetteskins

Advertise with the Corvette Action Center!

Double Your Chances!

Partners

Top Bottom