Mr Dark
Well-known member
I want to replace the headlight switch knob on my 85 when it comes out of winter storage, so I ordered a replacement knob. The replacement knob came attached to a shaft, so I tried to remove the knob. According to instructions I've seen, I just put a small flat-bladed screwdriver into the small slot on the side of the knob and push until it releases. I just can't seem to get it to work. There is nothing to push on to release. All I'm managing to do is gouge the plastic inside the knob. What am I doing wrong? I figure if I can't get the knob off the one that's not attached to the car, I'll be in deep doodoo trying to actually remove the one that IS attached to the car. I must be missing something fairly obvious here and would appreciate someone pointing out the error of my ways. Any suggestions will be appreciated!