LannyL81
Well-known member
- Joined
- Jul 20, 2002
- Messages
- 653
- Location
- Oro Valley, AZ USA
- Corvette
- 81 White/Cinnabar, 96 CE LT4 sil/blk
Hello again,
Got a sales catalog from Ecklers and saw 1974-82 Hood Alignment Bumpers; did the factory install these or is this strictly aftermarket?
On the right front edge, just across from the front wheel, my hood is lower than the fender, and there are rub marks in several places. But the front edge is great and everywhere else is fine, just the one area, about 6-8 inches long across from the right front wheel where it is low by about half the width of the fiberglass.
So I was wondering if I installed these alignment bumpers if that would help or make other things worse???
Thanks in advance to all,
Lanny
Got a sales catalog from Ecklers and saw 1974-82 Hood Alignment Bumpers; did the factory install these or is this strictly aftermarket?
On the right front edge, just across from the front wheel, my hood is lower than the fender, and there are rub marks in several places. But the front edge is great and everywhere else is fine, just the one area, about 6-8 inches long across from the right front wheel where it is low by about half the width of the fiberglass.
So I was wondering if I installed these alignment bumpers if that would help or make other things worse???
Thanks in advance to all,
Lanny