im in garage and need help

[regalniz]

just installed my new throttle body. everything went in fine but, when i hooked up the throttle cable the thottle does not close all the way. i idle at 1200 rpm. when i removed the cable the throttle snaps shut like its supposed to. does the cable need adjusting? what am i missing?

 

[*89x2*]

is the screw "stop" turned in too far :confused - take a look there - if not???????

 

[Ken]

... when i hooked up the throttle cable the thottle does not close all the way.

Is it binding anywhere? You state that the throttle blades close to the idle stop with the cable off right? There is no adjustment that I am aware of, so I think it must be binding somewhere. The new TB would not make any difference when it comes to throttle cable lengths.

 

[regalniz]

i fixed it. i did a little fabricating with the bracket that holds the cable and its all good. dont ask me to explain. thanks for your replies.