is the 08 vett obd-II compliant?

[txbikerdude]

about to buy a reader tonight but want to make sure.

 

[Hib Halverson]

All Vettes since 96 are OBD2.

 

[txbikerdude]

ok 1 more stupid question - it connects to the interface under the dash centered in the drivers seat (right under the steering wheel), right?

I get a "link error" when I try to connect

 

[yellow_2002_germany]

Your car has to be CAR-ON, ENGINE-OFF for the scanner to read the codes. You do that by holding down the bottom part of the starter switch until the guages activate.

 

[NORTY]

Did you get a code reader that can clear codes?

 

[douglasamariani]

What type of scanner are you using? Did you buy it new or used? If its used/old you may need to update the software. If its new and you are scanning your Vette in ACC or RUNNING mode than you have a problem with the scanner

 

[Hib Halverson]

ok 1 more stupid question - it connects to the interface under the dash centered in the drivers seat (right under the steering wheel), right?

I get a "link error" when I try to connect

Does your scan tester support the CAN protocol?

 

[danl72]

All Vettes since 96 are OBD2.

I agree.