Welcome to the Corvette Forums at the Corvette Action Center!

NGC Ultimate Factories - Corvette

nascarnbroncosfans

New member
Joined
Sep 25, 2009
Messages
3
Location
West Valley, Utah
I was watching the program - National Geographic Channel Ultimate Factories - Corvette

http://channel.nationalgeographic.com/series/ultimate-factories/3325/

Overview theres a mistake....

about 38 minutes into the program...

When they get to the point of the cross drilled front brake rotors and why they are cross drilled, """Holes in the front rotors help the engines gases escape faster""".... HUH? since when does the engine exhaust go thru the front brake rotors?
 
And the vents on the sides of the front fenders allow brake pad dust and heat to escape. :boogie
 
and.......when they go from the frame factory 60m miles down the road to bowling green..right there..in the parking lot, in front of the cooperate offices..is a polo green C4...its on screen for less than 1 second. but it's there....i figure it's the nite janitor...
 
The engine gas escape holes are one of those specially engineered Corvette exclusives!! That is what makes them so special, and expensive!! :W:W:W:W:W:W:W:W:W:W;help
 
and toward the end, i had finally learned enough about the zo6...
so...now all i have to do is calculate how to get one.
(it's good to have goals)
 

Corvette Forums

Not a member of the Corvette Action Center?  Join now!  It's free!

Help support the Corvette Action Center!

Supporting Vendors

Dealers:

MacMulkin Chevrolet - The Second Largest Corvette Dealer in the Country!

Advertise with the Corvette Action Center!

Double Your Chances!

Our Partners

Back
Top Bottom