Welcome to the Corvette Forums at the Corvette Action Center!

Question: No start

muddywaters

Well-known member
Joined
Aug 25, 2002
Messages
765
Location
wilkes-barre,pa.usa
Corvette
1988 white 4+3 coupe 99 Torch Red 6spd. coupe
Hi Guys it's been awhile, I replaced master/slave cylinder and hose on my 88 4+3, took great pains as usual, now I have a no start condition any ideas ? Thanks
 
Hi Guys it's been awhile, I replaced master/slave cylinder and hose on my 88 4+3, took great pains as usual, now I have a no start condition any ideas ? Thanks


Battery cables, dead or bad battery?
 
Clutch safety switch??????
You were definitely in that area...........
Andy :w
 
Battery is good, jumpered saftey switch still no start everything works won't start/crank
 
I'll check further 2moro I'm thinking I disturbed some wires fishing clutch hose threw
 
I'll check further 2moro I'm thinking I disturbed some wires fishing clutch hose threw



Make sure that the purple wire on your starter has battery voltage on it with the key in the crank position, if not trace it back to the ignition switch. If it does have battery voltage, have someone tap on the starter with a large solid hammer, with someone else holding the key in the crank position while the brakes are applied and the vehicle is in neutral.

If you didn't properly load test your battery, you may want to start there.
 

Corvette Forums

Not a member of the Corvette Action Center?  Join now!  It's free!

Help support the Corvette Action Center!

Supporting Vendors

Dealers:

MacMulkin Chevrolet - The Second Largest Corvette Dealer in the Country!

Advertise with the Corvette Action Center!

Double Your Chances!

Our Partners

Back
Top Bottom