ohm Injectors?

[UB2 SLOW]

Okay, I dont remember how to do this since its been so long. Can anyone tell me? I cant remember if I have to take them off or not.

 

[LT4man]

All you have to do is gain access to the electrical spades of the injector.

Off the top of my head, I do not remember the acceptable resistance.

I do know the values of the injectors need to be close in variance. This is more important than the individual values being in a certain range.

Very much like a compression test on an engine. The pressures need to be within a certain percentage of each other.

I am sure someone else will chime in with the value that is acceptable.

SAVE THE WAVE!

 

[Black Bart]

Pry the wire clip back and remove the wire from the injector. Using an ohm meter check across the two spades on the injector. A good injector will read 17 ohms

 

[UB2 SLOW]

Thanks guys. I didnt think I had to remove the injector, but I wasnt sure how to check it.

 

[UB2 SLOW]

Ok, I ohm'd the injectors and these are the numbers. 14.6, 14.7, 14.8, 14.8, 14.8, 14.9, 14.7 and 14.9.

 

[LT4man]

I would say your numbers are right on the money!

SAVE THE WAVE!