Power Passenger Seat

[89popalop]

Looking For Some Help.want To Make My Passenger Seat Power. Has Anyone Try This.how Tuff. Was It How Hard Was It To Get The Parts To Do The Job.any Help Would Be Great Thanks.

 

[mylt4]

I did this exact project last year. Worked out great. Got seat track off of Ebay, bought the passenger power seat switch and new bezel to accept both driver/passenger control units, from GM dealer. Took a little time to remove both seats, center console, but was pretty simple. Driver side power seat control has necessary connector to accept passenger control, so no experimental wiring was necessary. Takes a little work to get the wires laying correctly so the console will re-install easily. I think it took me no more than a couple hours to do the whole project.

Good luck.

 

[tlong]

I did this too, and was a good upgrade. Bought the power track and wire harness with the two switches from Jason at Vette2vette. Very reasonable.


Remove seats, install new track on passenger side, replace switches and run the new wire harness under the carpets, that's it. Carefull on the center console as there a bunch of little screws hiding inside the console under the carpet.

I had to modify the power wire into one as i couldn't find a compatible plug and play. No problem.

 

[89popalop]

Thank you for your help i am going to give it a shot let you know how i make out. Again thank you.

 

[89popalop]

Thank you for your input does not sound to hard to do.Will let you know how i make out.thanks again for your help.

 

[89popalop]

THANKS everyone for all your help.I hope this reply gets sent.