marathon26
Active member
- Joined
- Nov 13, 2004
- Messages
- 44
- Location
- Wichita, KS
- Corvette
- '13 N R Blue Metallic Cpe & '15 Crystal Red Conv
I took my '89 in to have the have the rear main seal replaced. They replaced it, but it was still leaking. They took it back apart and found that the seal does not seal on the top of the crank shaft. I went to the dealership and had a look. The solution is to take out the guide dowels and put it back together and see if it will make a better seal. My question is - after all this time how could the block be out-of-round so that the seal will not form properly to the crank or do they have a bad seal?
HELP! ad
HELP! ad