PMartin
Active member
I replaced the ECM and PROM today but the check engine light is still on. I did make some progress today because the car will now start and run when the wiring from the distributor to the ECM is connected. Which it would not do before I replaced the ECM. I tried to jump together the D&E terminals at the diagnostic port but could not get the check engine light to flash any codes the check engine light just stay on. The car still wants to hesitate and bog down when driving. It appears to run great in the garage but not when you get her out on the road it runs like crap. Does anyone have any ideas? I'm at a loss!
Thanks,
P Martin
Thanks,
P Martin