R
Robert
Guest
A few years ago I lowered my 84 about an inch and a half due to the rubber bushings on the front transverse spring going bad. So, I went to Mid America to get the longer bolts to lower the rear.
I was looking at it tonight and I think I may have the rear too low.
So, my request is to have one of the members with a stock ride height measure to the top of the black rubber strip at the leading edge where it curves around over the turn signals and at the rear just at the point where the curve begins.
All I need to know is the difference in the measurements so I can raise the rear to match the difference on a stock configuration.
Thanks,
Robert
I was looking at it tonight and I think I may have the rear too low.
So, my request is to have one of the members with a stock ride height measure to the top of the black rubber strip at the leading edge where it curves around over the turn signals and at the rear just at the point where the curve begins.
All I need to know is the difference in the measurements so I can raise the rear to match the difference on a stock configuration.
Thanks,
Robert