stop lights

[Jim D]

The stop lights on the passenger side stopped working. The taillights and turn signal work. Installed new bulbs , and tightened the ground, and took the connecter apart and cleaned ,still no work. Any idea's, thanks Jim.

 

[c4c5specialist]

HI there,
I would suggest that you hazard switch has an open circuit.
Simply cycle the swith a few times and your rear lights may work again.
Allthebest, c4c5

 

[Jim D]

C4-C5 , I tried switching hazards on and off, still don't work. By the way the flashers on the pass side don't work either, Should I replace the hazard switch, thanks Jim.

 

[c4c5specialist]

HI there,
It would be impossible to determine that without me doing actual diagnostics.
However, the switch and the turn signal switch has both been issues.
So, the hazard switch, when it was on, did that make the lights work?????? While the hazards were on?????
Allthebest, c4c5

 

[Jim D]

No the lights didn't work with the hazards on, Jim.

 

[c4c5specialist]

Hi there,
Then I would say at this point, it could be the turn signal switch more than the hazard, but it will all depend on accurate diagnosis of the actual right rear lighting circuits.
If you have options, I would go with the hazard switch first, due to the fact that all you have to remove is the upper dash pad.
Allthebest, c4c5

 

[Jim D]

Thanks, I'm taking it to the dealer nex week, as I also need a feul line check valve, thanks Jim.