Welcome to the Corvette Forums at the Corvette Action Center!

wheel bearing dust cover

nut4crew

Member
Joined
Jan 25, 2004
Messages
8
Location
Rapid City, SD
Hi,
I'm looking to repack my front wheel bearings and replace the rotors, and may need to replace the wheel bearing dust cap. However, I can't find the cover itself anywhere. I tried local parts stores, the Chevy dealer, and a few places on-line. It was suggested I have a machine shop make one...any other suggestions?
Thanks...
 
Wheel bearing Dust Cover

nut4crew said:
Hi,
I'm looking to repack my front wheel bearings and replace the rotors, and may need to replace the wheel bearing dust cap. However, I can't find the cover itself anywhere. I tried local parts stores, the Chevy dealer, and a few places on-line. It was suggested I have a machine shop make one...any other suggestions?
Thanks...
Have you tried NAPA ?
 
I had the same problem. Our size is not standard, I ended up using one that was slightly too small and machined a thin ring that I pressed in the housing first and then the undersize dust shield into that. It is not a solution for you.
Paragon reproductions would have the proper dust shield.
 
I think I got mine from Ecklers most recently - - less than $10 for a pair as I recall.

Regards-
 

Corvette Forums

Not a member of the Corvette Action Center?  Join now!  It's free!

Help support the Corvette Action Center!

Supporting Vendors

Dealers:

MacMulkin Chevrolet - The Second Largest Corvette Dealer in the Country!

Advertise with the Corvette Action Center!

Double Your Chances!

Our Partners

Back
Top Bottom