A few days ago my drivers side window on my 95 Hatchback wouldn't go down. A day or 2 later it worked fine but then stopped working once again. Am I correct that by removing the 2 screws in the door pull I can access the window switch?
Window problem
- Thread starter lsmith103
- Start date
BC72067
Active member
I'm ordering this set of window regulators for my 96 Friday. A week after I bought it, it did the roll down and continue to run same when rolling up.
There are a couple links to removing the door panels to. Not much to it.
Corvette 84-96 Window Regulators Pair
https://youtu.be/aJx8RgaiLkw
https://youtu.be/3dzebFBuIMo
I figure I will do the drivers side and put the passenger one in the shop until needed or I get bored on a Saturday and need something to do.
It's also going to get a set of NGK Laser Iridiums and new wires, K&N air and oil filters, and a fill for 3000 miles of Royal Purple to loosen up and knock the cobwebs loose.
I figure it will cost a bit and take a little time to figure out where all it was neglected and get it back up to snuff.
There are a couple links to removing the door panels to. Not much to it.
Corvette 84-96 Window Regulators Pair
https://youtu.be/aJx8RgaiLkw
https://youtu.be/3dzebFBuIMo
I figure I will do the drivers side and put the passenger one in the shop until needed or I get bored on a Saturday and need something to do.
It's also going to get a set of NGK Laser Iridiums and new wires, K&N air and oil filters, and a fill for 3000 miles of Royal Purple to loosen up and knock the cobwebs loose.
I figure it will cost a bit and take a little time to figure out where all it was neglected and get it back up to snuff.
Last edited:
Similar threads
Corvette Forums
Supporting Vendors
Dealers:
