Hood Issue
Wow, the "correct" solution would be alot of work. Can it be that the car is that far off from the factory? Looking at your hinge photo, I see the bolts for the top and bottom hinge halves do not overlap. I wonder if slicing the bottom of the hinge below the pivot point with a cut...
I have a '63 convertible with a hood alignment issue. The front edge of the hood sits about 1/4 inch above the headlight panel. There are no shims to remove under the hinges. The Corvette assembly manual mentions adding shims to raise the front of the hood but no incite on how to lower a high...
You are both correct. I found some casting numbers on the trans, specifically P9R014 which my research indicates a Muncie trans manufactured in October of 1969. It is interesting that the cable is currently routed through the early grommet and does fit but the cable comes quite close to the...
This may be a simple question for some but I'm stumped. I have a 1963 Convertible with a fourspeed. The Corvette Assembly Manual and Corvette Shop Manual both show the speedometer cable connected to the driver side of the transmission tailshaft but my cable connects to the passenger side of...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.