Before there were high tech front end glass springs or coil overs I went with the heavy duty "F41" front and rear springs from VBP. This was before "forums" too. I now know many say these are too stiff for all but the best shocks and not to use them unless you race. They definitely bring out the...
This leaking has been discussed a bit on one of the other forums. I found my problem was the Positive strap broken in two under the tubing and the rheostat seemed worn out. So instead of wasting $80 on a cheap one that's likely to leak or $300++ on a genuine, I sent mine to John Wolf last week...
I just got mine back on the road after replacing my water pump. Now I can get back to my distributer fine tuning I was working on! It's been in the 60's and perfect driving weather here!
Sure, you can use the hammer and chisel, but the difference between Corvette owners and Mustang owners is, we can make tools...I saw that on National Geographic once.
Hmmm, I'm getting tired of my leaking Tri-Power, but I don't think this puppy will fit even under a 67 BB hood. Or will it, anyone try it??? How about one of those new BD Tri-Power set ups?
Drjohn, I submitted this same question on the Holley online tech page under carbs and manifolds. I got a reply that it was for new products and he gave me the correct phone number. When I looked at my receipt from Holley the other day, I saw it was dated 2/6/98. 10 years to the week! The...
Kid Again,
I found your old post about your leaking 2300’s. I think I’m having the same problem. This is my theory: Mine leak well after they cool down, I’ve checked them after a couple hours when the intake/carb are around 65 degrees, no leaking. The next day when it’s down to about 45 degrees...
I had lowered the fuel level to at least an 1/8" below the plug, I haven't changed anything else on the secondary's since I installed them. These have been doing this for a while but I've written it off as the seal on the bowl or a stuck gas cap vent. Holley rebuilt them but didn't mill the...
Save the LEAKING HOLLEY JOKES!!!:D
My carbs were restored by Holley several years ago. A couple years
later the end carbs started to soak the throttle body gasket and carb
base gasket after it cools down. This is well after it has cooled down
and is not heat soak boil over. This may be worse in...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.