Welcome to the Corvette Forums at the Corvette Action Center!

Search results

  1. jstkrsn

    Help - Dana 36 Carrier swap

    I bought a Dana 36 3.07 complete carrier to replace my 2.59. Should fit right? Well I found my first glitch. The new one is from an 84, and mine is a 92. The spindle support rod bolts on the 92 were 1/2". The 84 has holes for 3/8" bolts. The area around the whole on the 92 is larger also. As I...
  2. jstkrsn

    Swapping Carriers

    Has anyone changed the rear ends? I have the whole carrier setup, cover and all to install. I'm putting in a 3.07 to replace my 2.59. Any difficulties I will run into? Do you have to use the leaf spring compressor or does it just make it easier? Would appreciate any pointers before I start...
  3. jstkrsn

    Ebay Computer Controller

    Anyone know what this is? http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=1862695207 I haven't seen one of these before.
  4. jstkrsn

    Unichip

    Does anyone have any experience or know anything about the Unichip programmable computer for OBDI cars. It's very expensive but it will reprogram like they do with the OBDII cars(ie Hypertech Power Programmer). It fits in between the ECM and the Engine. The stock chip remains intact. It's...
  5. jstkrsn

    Alternator/Regulator?

    My battery keeps running down. I can charge it right back up with my charger, so I think it is OK. After I charge it up and begin driving my gauge says 13-13.5 volts. It starts decreasing from there. Down, Down slowing as I hit the brakes, turn on the air with the fan, radio etc., to near 10...
  6. jstkrsn

    Performance Exhaust Manifolds

    I just bought a set of SLP shorty headers (Performance exhaust manifolds) to replace the heavy cast iron ones that are on my 92 LT1. They look almost like the exhaust manifolds that were on my 86 L98 (W/aluminum heads). They were constructed out of steel pipe also. When did they go back to the...
  7. jstkrsn

    LT1 Ignition Wire Replacement

    I'm replacing the wires and plugs. Did the easy side. Now I'm on the hard side. Removed the inside wheel well shrouds. The plugs look accessable. But what do I have to remove to get at the OptiSpark to replace the wires at that end. I can't even see where they connect. The diagram in the...
  8. jstkrsn

    Tps

    This isn't on my vet, but my other GM car, an Olds Aurora. It idles OK, revs OK when on WOT to 6200. but when doing 30-40 and give it a little gas it hesitates, stumbles, surges like its running out of gas. I changed the O2 senser. I barely pased my HC and the smog guyu thought it was the O2...
  9. jstkrsn

    100 octane gas

    The station done the street started selling 100 octane racing fuel for $4.50/gal. Anyone know if this would make a difference? I have a hypertech Thermo chip. They say it is programed for 93 octane. I've been putting 92. Would it be worth while for racing only? Also my car has been...
Back
Top Bottom