I found out there is a difference, the modulator valve (pump) comes with and without active brake control. Just a fyi the part number of the modulator with the active brake control is 10417038 which is the V version.
Does anyone know if the ABS pump (it's a 2000 corvette) can be used with either the M or V electronic module? My electronics are ok but the pump has bad threads on one of the output ports. The existing unit is a V.
My key rotates in the ignition after some effort of pulling in and out and wiggling. I purchased a new ignition lock cylinder and tumblers, but the cylinder does not look like the one in the factory manual, has the Mickey Mouse ears around the key. Does anyone have a diagram showing the C5 lock...
Training and learning are the same. During the "process you should be asked for the second fob to train. Is the battery new? You should try to hold both the lock and unlock buttons at the same time standing near the car after replacing the battery if needed.
Mine also had a problem that was intermittent and the problem was the solder joints of the crystal oscillator in the top right hand corner (key slot down).
Thanks,
FLIR_man
Starting at light the car went out of drive went back into drive with a loud bang. Then there was a high squeel and no real forward motion that matched the engine speed. Nursed it back to 45 then everything was ok going forward. When I started the car after setting it will not go into reverse...
I had the same problem on my 2000 and it was the "dog bone" links at the end of the torsion bar. I also changed the bushings since I was under the car.
Daga
My guess would be a ground connection for the steering rate sensor return. There are many post on ground locations and how to clean. I would try that before I bought a new rate sensor.
You need to look at the codes. There are many things that cause the active handling warning to come on. Press and hold the options button while pressing the fuel button four times and the codes will be displayed.
Hold the options button down while pressing the fuel button four times. The car will go through all of the computers and list what the codes are if any. HVAC comes after the Radio. BTW not stupid for asking!
The gear is close to "total" failure. The noise you hear is the motor turning and the stripped gear not turning. It will not be long before the light will not raise. There is a person on ebay that sells brass gears.
Check your codes. I learnt a valuable lesson this weekend, trust the GM engineers.
I had hot air coming out the driver’s side and cold air coming out the passenger side of the HVAC ducts. Reviewing the forum I came to the conclusion that I was low on Freon. I started to add Freon and the...
Check your codes. I learnt a valuable lesson this weekend, trust the GM engineers.
I had hot air coming out the driver’s side and cold air coming out the passenger side of the HVAC ducts. Reviewing the forum I came to the conclusion that I was low on Freon. I started to add Freon and the...
I had an issue of the headlight not coming up after the gear fix and it was because I did not leave enough clearance between the back of the headlight body cover and the hood. The clearance was just enough for the headlight to elevate sometimes.
Thanks,
Gary
In the end I had to replace the module and the motor pump. I did the module first and the pump second. I now have 93K miles on the car and everything works great. I got both parts off ebay and made sure that the part numbers matched the original unit. I had not thought about it when I first...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.