glen3107
Active member
For the last couple of days, my auto controls on my HVAC module have been going haywire. The temperature setting readout goes dim and then bright and changes from 72 to 75 then to 60. Also, while I'm driving the unit changes itself from auto to bi-level to heat and then back again.
I read the previous posts and disconnected the battery to see if the unit would reset itself. It did. Then I drove about 4 miles and it started acting up again.
Do you'all have any advice on what could be causing the problems that I'm experiencing?
Thanks
I read the previous posts and disconnected the battery to see if the unit would reset itself. It did. Then I drove about 4 miles and it started acting up again.
Do you'all have any advice on what could be causing the problems that I'm experiencing?
Thanks