Just got an SES light on my LT4. Pulled a PO118 (ECT Sensor). At the same time both my temp gauges (analog & digital) basically quit working.
Had some work done at Exotic Muscle and I think they might have broken it (or disconnected it)
when they re-installed my camber brace. Is the the ECT Sensor located in front of the engine near the water pump? I remember (vaguely) that the instructions for the camber brace install said to be careful not to damage "sensor" when working in there, but I'm guessin' that the sensor they were referring to was the ECT Sensor. Am I right? What are the implications of the sensor being bad and is it an emergency fix or can I wait a few days and drive it like this until I can get it back to them? Car is my daily driver...
Car seems ok but I don't want to @#$! up anything else by not fixing it right away.
URGENCY LEVEL????
Thx,
Jeff
Had some work done at Exotic Muscle and I think they might have broken it (or disconnected it)
when they re-installed my camber brace. Is the the ECT Sensor located in front of the engine near the water pump? I remember (vaguely) that the instructions for the camber brace install said to be careful not to damage "sensor" when working in there, but I'm guessin' that the sensor they were referring to was the ECT Sensor. Am I right? What are the implications of the sensor being bad and is it an emergency fix or can I wait a few days and drive it like this until I can get it back to them? Car is my daily driver...
Car seems ok but I don't want to @#$! up anything else by not fixing it right away.
URGENCY LEVEL????
Thx,
Jeff