Engine Wiring ID Needed

[LannyL81]

Hello,
Need help to ID some cut wires in the engine bay. The location is just below the bracket where the vacuum sensor (MAP) attaches to the firewall, best location diagram is in the manual, fig 8A-91.

I have three cut wires: dark green, brown, and black....and am trying to determine what these went to. I have been searching through the schematics of section 8 with no luck.

Anyone happen to know anything about these three wires?? Would sure appreciate it.

LannyL81

 

[LannyL81]

NEVER MIND.....figured them out. I had actually cut the wires to the EGR relay. Do not understand why I would have cut them, but I did.

 

[bill81vette]

Don't worry about it ....just go have another beer!!!!