gkurtz.
If it is what I am expecting...ie, headlight motor is spinning for 3 pr 4 seconds after the doors are completely open or closed it has to be the "Delrin Bushings". I would suspect even though you have only a few miles compared to my '92 time is a factor...water getting in the gearbox and freezing...etc. the factory "Stuff" that is "Packed" in the gear box housing is NOT a bushing from what I've seen in the past but a mere epoxy type substance that will breakdown over time or wear....it is quite a detailed job to do this. first you must disassemble the motor assembly from the headlight. then very, VERY carefully take the gear box apart. Then thouroughly clean out the residue and put in the mew bushings. then re-assemble. Seems very simple but it is a real pain in the sitting spot due to the tighness of the space you are working in. You can remove the entire headlight assembly and then remove the motor and gear assembly but I chose to just try and take off the motor assembly. I did this several months back and have not had any more trouble with thie motors spinning or making the noise I think you are speaking of. The instructions with the bushing kit are very vague at best and do not go into detail needed to complete the job. You have to use a little common sense when doing this. GOOD LUCK! Tim