Installing Spark Plug Wires?

[markbuldyke]

How am i supposed to install spark plug wires on a 1993 C4 corvette. It seems that i will have to take the whole engine apart just to get at them. Any help would be appreciated.

 

[rascal_rascal_99]

Hi there, first off welcome to CAC!!

As for plug wires, they aren't fun, that's for sure...it can be done without pulling the water pump, I've done it...but I doubt I'd do it the same way again. If you haven't seen THIS THREAD go and read through it to see what myself and a couple of others have had to say on the subject.

 

[doggiedave]

I have a 90' model, and I know that I'll be flamed by the resto guys, but, I ran a set of MSD 8mm red wires (red coupe) over the top to save aggravation they have bendable plug boots and there is plenty of room for routing and they look nice and are easily accesible found chrome looms and then used some of the factory clips to complete. just say'n

 

[rascal_rascal_99]

I have a 90' model, and I know that I'll be flamed by the resto guys, but, I ran a set of MSD 8mm red wires (red coupe) over the top to save aggravation they have bendable plug boots and there is plenty of room for routing and they look nice and are easily accesible found chrome looms and then used some of the factory clips to complete. just say'n

I doubt you'll get flamed...I think it's a perfectly fine idea for your car! Difference is though, a 90 had the L98 motor and what I guess you would call a more conventional distributor location, where the LT1's have the thing stuck on the front end of the motor.