Welcome to the Corvette Forums at the Corvette Action Center!

P/S relay rod replacement

Jeff Farrar

Active member
Joined
Jul 20, 2004
Messages
44
Location
Pittsburgh, PA
Corvette
67' BB Convertible
I need to replace my P/S relay rod (bent). Once I disconnect it from the idler arm and both tie rod ends, does it just unscrew from the control valve? I'm not at home where I could look it up in service manual. I see were the supply houses sell a larger replacement from the C3's at a much lower cost than an original. I "assume" the fit just fine?

Thanks.
 
Just remove the clamp bolt from the valve where the relay rod attaches, and the relay rod will unscrew (the bolt has to come all the way out due to the flat milled in the threads to clear the bolt). The replacement relay rod that most of the vendors sell is the larger-diameter C3 part, but it will fit a C2 just fine.

:beer
 

Corvette Forums

Not a member of the Corvette Action Center?  Join now!  It's free!

Help support the Corvette Action Center!

Supporting Vendors

Dealers:

MacMulkin Chevrolet - The Second Largest Corvette Dealer in the Country!

Advertise with the Corvette Action Center!

Double Your Chances!

Our Partners

Back
Top Bottom