Welcome to the Corvette Forums at the Corvette Action Center!

ring and pinion

C

c5blue

Guest
hi there

i'm look'n for ring and pinion 3.47 ratio for my A4 c5 ...
where could i find it ....
 
Hi there,
YOu can get a 3.42 rear axle ratio, fully assembled, and ready to go.
There are many vendors that have them, however, you may want to check here, before searching.
GM does not allow these axles to be rebuilt, as there is no special tools to correctly set side carrier preload.
YOur best reliability will be to purchase the whole differential.
Besttoyou, c4c5:hb
 
As usual, c4c5 is right, you will have to replace the whole unit. The first c5 diff i pulled out I had intentions of rebuilding it. After researching it I discovered that GM does not want you rebuilding them. If I were to switch ratios I would get a whole unit, I wouldnt trust one with just the r+p changed.
 

Corvette Forums

Not a member of the Corvette Action Center?  Join now!  It's free!

Help support the Corvette Action Center!

Supporting Vendors

Dealers:

MacMulkin Chevrolet - The Second Largest Corvette Dealer in the Country!

Advertise with the Corvette Action Center!

Double Your Chances!

Our Partners

Back
Top Bottom