hello everyone,! need some info on the insert with the vette emblem from the steering wheel..the whole insert poped off. Is this just glued in place?? There are no other gaskets or rubber retainers. Is there any special glue or crazy glue the best. Thank You!! :confused :confused
I assume you are talking about the horn button emblem?
I have replaced my emblem in the horn button using "J B Weld" brand two-part epoxy (as advertised by Paul Harvey). Follow directions, clean mating surfaces very well, scuff with light sandpaper, and DO NOT use too much epoxy, It will squeeze out and be visible from the outside.
This emblem was originally held on by 3 rivets. They must be removed or have been removed in the past by someone else to get the emblem out.
Thanks, FASTGLASS 95...I'LL TRY HOME Depot to see if they have it. You guys and gals are great with all of the answers. Hope I can be of help someday.. Thanks again..
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
