- Joined
- Jan 24, 2002
- Messages
- 229
- Location
- Binghamton, NY
- Corvette
- 1981Dark Blue Metallic & 2004 conv. magnetic red
Well folks I really think I have a problem, I bought new bushings for the back of the T-top and was trying to pull what was left of the old bushing out. After no luck I unscrewed the pin and tried again so I lifted the locking lever to insrt a hook to remove the old one. I tried to screw in the pin again and it slid in and now I cannot get it out, I guess if I had left the lever in the locked position the pin would have screwed right back into place.
I dismantled the locking lever from the rod but I cannot get the rod out.
How do I open up the pocket where the rod runs inside the T-top. The screws that hold the gasket on are very rusted and I put 10W40 on them last night in hope of removing them would help.
Please help!
Signed Dumber and Dumbest also known as Chuck
I dismantled the locking lever from the rod but I cannot get the rod out.
How do I open up the pocket where the rod runs inside the T-top. The screws that hold the gasket on are very rusted and I put 10W40 on them last night in hope of removing them would help.
Please help!
Signed Dumber and Dumbest also known as Chuck