Who's Got A Pic Of The Clutch Push Rod

[Viet Nam Vett]

I need a Pic of the Clutch Push Rod at the adjusting point where it connects to the "Z" bar lever. I need to see how much thread is on each end of the sliding pin block.

Any one have one hady.....


oh yeah.....like we all have a pic of that just sitten in our puter...:L

 

[lone73]

weird pis

I could send you one but I don't have a site to post on.
.
.
.

 

[Viet Nam Vett]

I could send you one but I don't have a site to post on.
.
.
.

You can email it to ..mrkrichman@comcast.net

Thanks

 

[Paranoid]

oh yeah.....like we all have a pic of that just sitten in our puter...:L

:L

 

[67HEAVEN]

I need to see how much thread is on each end of the sliding pin block.

That depends on your specific car and your preference for clutch free play.

 

[Viet Nam Vett]

That depends on your specific car and your preference for clutch free play.

Well This is why I ask. I think this is where I had left My adjustment when disconnected. Either way ...this super duper Heim Joint rod is to long and I want a pic to send to the mfg.

I wanted to see the average place where the sliding block ends up. I know it will vary. But this Rod will not go in any further.

 

[Viet Nam Vett]

:L

Thanks for the pic....If I get any more I'll compare.. Thanks again....

I know you went out and took this pic......Didn't You...:L

 

[Paranoid]

Thanks for the pic....If I get any more I'll compare.. Thanks again....

I know you went out and took this pic......Didn't You...:L

Actually No, I had it in my files. I'm a wacko. I probably have a picture of just about everything. :L I was surprised I could actually get to use one.

 

[Viet Nam Vett]

Actually No, I had it in my files. I'm a wacko. I probably have a picture of just about everything. :L I was surprised I could actually get to use one.

Cool...it paid off..!!:L