I installed 2002 corvette seats in my 78. I used the factory 78 seat brackets, stripped the seats down to the aluminum frame, then attached the stock brackets to the aluminum frame. I had mounted the seat rails to the floor, placed the seat on top of the rails, did some calculations on the angle...
I recently finished up my stereo upgrade on my 78', and thought I'd share the final product.
First, thanks to everyone before me that posted notes and photos of their stereo/speaker/amp install. They were very helpful and instrumental in designing what I consider a very well rounded audio system...
My AIM manual has only odd pages from 17 on (go figure!). The specs for Standard Trans is on either page 18 or 20. Anyone have copy? Or if someone has the correct speedo gear for the 3.70, can you post?
I took the plunge and swapped out my 3.36 gears for a set of 3.70. Since most of my driving is cruising, the few hundred extra rpm's on the freeway don't' bother me much.
Except that my speedometer is now off. Showing 70 it is actrually 60 (using GPS).
I have a saginaw tranny, so which...
Gary,
What kind of issues did the 78-79 years have? Wasn't aware of any.
Why those years? 1) I have a 78 and if i'm correct, it would be a direct bolt in as the yoke sizes are the same. 2) without having to rebuild one, my thought was a lower miles 3.70 differential would be a better option than...
Howdy all!
I'm looking for a good usable (bolt in) 78-79 rear differential with 3.70 gears; OJ code.
Anyone have one for sale or a lead on where I can find one?
Thanks
Shawn
WTB 78 -79 Rear Differential 3.70 gears OJ code
Howdy all!
I'm looking for a good usable (bolt in) 78-79 rear differential with 3.70 gears; OJ code.
Anyone have one for sale or a lead on where I can find one?
Thanks
Shawn
I am in the process of converting my 78 seats with C5 seats. I recently purchased a pair of Tan (light Oak) 2002 seats off of ebay w/o seat tracks. Unfortunatley the seller did not disclose that the drivers side had the bezel/control/lever removed. I need those parts to cover up the gapping...
JohnZ - before disassembly, I did a complete oil change. Then ran the motor with for a few minutes with new oil/filter then drained the oil, removed the filter, pulled the pan & pump. I Thoroughly cleaned out the pan & will replace the oil pump with one from Summit.
I checked the cam bearing...
Here's a question(s) and suggested feedback for those that run either Comp Cam XE268, XE262 or NX262.
First here is my set up:
78 L48
Cam (current stock) - well after this weekend, none. I collapsed a lifter and flattened a lobe on the #4 exhaust.
Heads: Edelbrock RPM
Intake: Edelbrock EPS...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.