Search results

Mine looks like the original one. I might have the wrong instruction sheet? Hypertech (Ecklers i brought it from) never said anything about piggyback. Steve

He only had one :-( Had a friend working at GM back in 1993 and he gave him one for spare. Car sold years ago and the box stored all this time and in its original packing :-)

It is all up to you. I did buy a Hypertech to have better fan controll as i run a cooler termostat. I did not do it for the Hp and for my use the original 300 is plenty. It might save you on miles to gallon but then again these cars is quite good on the consumption as they are. I´ve done some...

I brought a Hypertech EPROM a while ago as i run on a Hypertech termostat which is cooler than the original. The problem is that the instruction which came with it sounds as it is to be put in together with the original EPROM. Is that a fact or is it me reading it wrong. I always beleaved that a...

I just brought a brand new boxed ECM on eBay :-) $299 and that included the PROM. I cant use the prom as it is configurated for manual transmition and i have automatic but i am still very pleased. Regards, Steve

New shocks and new brake pads. Install a MSD 6AL i have in the garage and and a possible spray job. The spray is pending, cant make up my mind on refresh the original or magnetic red II. I also have new injector from "fic" in the garage and finally a good wash inside. When the snow comes its...

I cant find the name magnetic red II in the color charts. Is it a nick name? Do you have the full code for that paint on your car, it´s beutifull. Thanks, Steve

thanks. a beuty you have there:)

Anyone out there with one who can post a picture. Thinking about a color change and magnetic or candy is the two colors i am thinking about. Have a white interior and think this will make a nice combo. Steve

If you look at your soft top and the pins you press in to the holes made in the deck lid. Same pins should be under the hard top. You dont normally remove them so they are most likely there. Then as you said two brackets (one each side) which bolt to the car and hard top. In front there are two...

I did the diagnostic test and when set to max cold #24 shows -153 (253) as it suppose to but on full heat it comes with 02, not 00. Does this mean it is operating but wont open full for heating? I do not want to mess with that door if i dont have to. Steve

When i say off i meen the whole heater/AC system. I have the electronic controll unit with a off position. When i turn the unit off the rpm drops.

When switching off the heater the rpm drops. Is that normal? Anyone tried to put it on/off when ideling and have the same? Steve

Thanks all of you:) Steve

Automatic

Thanks Hib. Any trick to replace? Steve

My 1993 idles at 800 rpm when warm, is that to high. She idle nice, just high. Thanks

Hi. I looked through my FSM but cant find the fuel filter :confused Anyone who can tell me where it is on a 1993 convertible and if it is a easy way to replace it. Thanks, Steve

Update on this. Had the car back from the garage and it was the opti which failed. It now has a new MSD vented opti, new MSD coil, new ignition module, new high flow water pump, 160 degrees thermostat, new spark plugs and new MSD plug wires. I have the 6AL in the garage and will install that...

Any for sale? I need one:) Steve