change oil light

[Stogie D]

mornin all - I changed the oil in my 1990 - how do I turn off / reset the change oil light? - Thanks, D.

 

[toptechx6]

​

Oil Change Light Shut-Off Procedure​

1. Turn the key to the RUN position but don't start the engine.
2. Press the ENG MET button on the Trip Monitor. Within 5 seconds press the ENG MET button again.
3. Within 5 seconds of step 2, press and hold the GAUGES button on the Trip Monitor. The CHANGE OIL light will flash.
4. Hold the GAUGES button until the CHANGE OIL light stops flashing and goes out. This should take about 10 seconds. When the light goes out, the Engine Oil Life Monitor is reset. If it doesn't reset, turn the ignition to OFF and repeat
procedure.

 

[Stogie D]

Thank you sir - much appreciated - FYI this model, 1990, does not have a Guages button - after dinkin around with it for a few minutes, it was holding the Range button that did it - Thanks again, D.

 

[toptechx6]

Glad you got it sorted out, the instructions were from my 93 owners manual