tpivette89
Active member
took a trip to Xotic Motorsports today for some dyno runs in my bone stock 93' LT1 6speed 40th anniversary Corvette. made 2 pulls, the best of which was 266rwhp/306rwtq. dividing by .85 for losses through a manual trans and that gives me outputs of 312hp/360ftlbs! thats 12hp and 25ftlbs over the factory rating! not too bad for 100% factory stock car!
i still think my results could have been better... my plug wires are still original (11 years old), and ive been getting an ESC code which most people say can be cured by replacing the knock sensors. im swapping out these items for new peices and heading back down to the dyno, i think i can do a tiny bit better
BTW- i did run my car at the track last night. best pass was a 13.63 at 104.84mph with a 2.17 60ft. i just cant seem to get the right amount of throttle application and clutch slippage for the perfect launch. it either bogs or the tires go up in smoke!
i still think my results could have been better... my plug wires are still original (11 years old), and ive been getting an ESC code which most people say can be cured by replacing the knock sensors. im swapping out these items for new peices and heading back down to the dyno, i think i can do a tiny bit better
BTW- i did run my car at the track last night. best pass was a 13.63 at 104.84mph with a 2.17 60ft. i just cant seem to get the right amount of throttle application and clutch slippage for the perfect launch. it either bogs or the tires go up in smoke!