Help! Window Adj. with new Regulator

[jwawhite]

The window adjustment on the Drivers door is at its end and yet I still have wind noise coming in the cab. If I understand correctly, the window tilt in or out is controlled by the 6 mm inverted torque behind the the door panel reflector. This bolt has been turned clockwise to its end in increments.

suggestions?

 

[jwawhite]

More on Adjustment

Perhaps the window does not travel up enough to cut out wind noise...there are 3 adjustments; from facing window, left to right adjustment, up and down adjustment and the old "in and out adjustment" against the weather stripping.

Plan of action: Will turn the Torx screw counter clockwise for "in and out" back to starting position (taken from old regulator). Will keep track of how many turns on the "up and down" adjustment to ascertain if this is the issue.

I believe the L and R adjustment is in the correct position from marked blue tape on window prior to removing window and old regulator, this should not be the issue.

Comments anyone?