the one at
www.nakidparts.com is the best one out my whole club has them and they even sell them at ecklers
To say that one switch is "best" is absolutely ludicrous and completely unfounded. My home built, DIY switch that I made from $24 worth of parts is no better or worse than the one you got from nakidparts. Basically, the technology is very, very simple. All it amounts to is a remote controlled on/off switch. That's like saying my light swich is better than yours.
I'm very familiar with the high priced switch you refer to. The components are virtually identical to my DIY unit. The difference in price covers a big fat profit margin for the reseller and magazine advertising.
Some people don't like to tinker, some do. For those that don't like to tinker and want a plug and play exhaust switch for NPP or Z06 then I recommend the $50 2 button or $60 1 button switch from Sunset Orange Creations. Either one comes with a full, lifetime warranty that even covers the remote batteries! How much more can you ask for in quality and quality customer service?
And good news for those with the new visor switches i.e. as found on an '08 Coupe or Z06, Sunset Orange Creations will soon be announcing a switch that is compatible with your visor buttons - you won't even need a fob. How cool is that?
See their selection here:
http://www.sunsetorangecreations.com/Products.php
Here is the DIY info:
Here is a great toy for the C6Z06 at a bargain price. I tried pulling the fuse but didn't like the drone at low RPMs. I didn't want a hard wired switch because that required drilling and running wires, etc. Not what I wanted to do with my new Z06.
A friend of mine, Bob Franklin, hooked me up with a great alternative. It's a remote control switch which is either controlled by the included key fobs or the Homelink buttons on the visor, if so equipped.
I recently found out that you can get an item called Add A Circuit from your local auto parts shop which is much easier than cutting a fuse and soldering.
Just plug in the part numbers (without the “#”) in the search window and it will bring up each component.
Link to parts:
http://allelectronics.com/
THE PARTS ARE AVAILABLE AT ALLECTRONICS
AT 800 826-5432 OR ONLINE ALLELECTRONICS.COM
1 #RC-10 $18.75 KEYCHAIN REMOTE
1 #FHP-25 1.50 FUSE HOLDER
1 #FSA-10 1.00 ATC FUSE 10 AMP
GET AN EXTRA FUSE LIKE THE ONE IN YOUR
FUSE BLOCK FOR THE EXHAUST.
THE ONLY REAL WORK IS PREPARING A FUSE
AS THE CONNECTOR TO YOUR FUSE PANEL.
FIRST WE ARE GOING TO BLOW THE FUSE, DO
THIS BY TOUCHING ONE SIDE TO BATTERY
AND THE OTHER TO GROUND, AFTER THAT IS
DONE, YOU NEED TO FILE TOP OF FUSE TO
GET TO METAL TO SOLDER TO, SOLDER THE
RED AND WHITE WIRE TO THE FUSE. AFTER
THAT, CUT THE RED WIRE ABOUT 4 INCHES
UP FROM THE FUSE, REMOVE ABOUT 2
INCHES OF THE RED WIRE. THE FUSE HOLDER
WILL GO IN BETWEEN THE TWO RED WIRES.
YOU CAN PUT HEAT SHRINK INSULATION ON
THE CONNECTION OR TAPE THEM. PUT A 10
FUSE IN THE HOLDER. ON THE BLACK WIRE,
PUT AN WIRE EYELET AND ATTACH IT TO
GROUND SCREW OF THE BCM MODULE. PLUG
DEVICE INTO FUSE BLOCK WITH RED WIRE TO
RIGHT. IF YOU GET IT BACKWARDS, NOTHING
WILL HAPPEN, JUST WONT WORK.