Recent content by TedC

Just purchased my third C4. This time a 1996 LT1 Coupe.

Appreciate the comments. I used the data center to better understand which automatic and engine by year. 2005 - 4 speed auto with LS2 2006 to 2007 - 6 speed with LS2 2008 to 2013 - 6 speed with LS3 They all use the same tire sizes, so replacements should not be an issue long haul. So far in my...

Currently own a 1989 vette with auto that has been extremely reliable and a joy to own. I've noticed several C6 vettes with low mileage (30-40K) for under $25K. I'm after a base model coupe with auto, leaning towards a LS3 engine with 6 speed auto. Any C6 years I should avoid? Please explain...

Do you mean the front and rear wire screens?

Timmy, Do you have the service manual? If not, well worth the investment. I picked mine up on e-Bay. Need more info... Is this a new issue? I would start out checking the TPS (throttle positioning sensor). You will need a VOM. Voltages need to be checked with engine off at idle and WOT? Plus a...

Additional info... The cold start injector was not replaced, just the 8 cylinder injectors. On my 1989, GM eliminated the cold start injector.

Leaking injectors??? On my 1988, the engine was hard to start during hot soak conditions. Plugs would be wet with gasoline. I tested/measured the fuel pressure as per service manual and could watch the rail pressure drop faster than they should with the engine off. If you don't have a pressure...

All the best Junkie!!!

I stand corrected. According to the FSM under Theft Deterrent System it states "When the Pass Key Module is replaced the new key code may not match... New key needs to be cut...". Regardless, it looks like trial and error until you find the right one that matches your new module.

Boomdriver, 1 402 2 523 3 681 4 887 5 1130 6 1470 7 1870 8 2370 9 3010 10 3740 11 4750 12 6040 13 7500 14 9530 15 11800 When the VATS module is first used it senses the key resistance and is "programmed". Dealerships only needed to stock one part. If the module you...

Look at the rear of engine, on the driver's side, across from the distributor. It may help to remove the rear plenum plate cover. If you are seeing constant high values around 80, I would check for a disconnected wire to the oil sending unit or an open circuit. If your 1988 is like my 1989, you...

Single volumes started in 1989. This changed back to two volumes some time in early 1990s. The single 1989 - 1992??? manuals included the eletrical section.

89vetter, Do you mean extra long cranking time after hot soak? This is the issue I had on my 1988, and it was caused by leaking injectors. When hot, it would restart right up to a minute or two, or after 15 minutes. In between, the injectors were leaking causing an extra rich condition.

DarkRed89Flyer, Do you feel the engine is running hotter now than it did before the intake manifold gasket swap? Two coolant openings are blocked by way of the gasket. The blocked openings are installed towards the front of the engine.

Did you lower the air pressure in the rear tires? If I punch the pedal on my 89 auto with 3.07 axle, it generates too much wheel spin. Looks like you ran will a full tank.