IH2LOSE
Well-known member
- Joined
- May 24, 2001
- Messages
- 3,908
- Location
- We Will All Meet Again
- Corvette
- 1966,and a 1962 thats almost complete
Well I am a little nervous about the winsheild rebuild this week end,I keep stairing at it and it just does not look so complacated (thats the part that is making nervous)
So I am going to have dish detergant as a lubrecant.
a bunch of dull edged putty knifes
All of my hardware ready to be installed.
some duct tape,
Some racheting binding straps.
Some twine.
a small rubber mallet,
Some surgical glove (hopefully to keep my hands from slipping)
My aim
Now when I removed my windsheild glass from the frame there was some dum dum in the corners,was this factory? why was it needed,where do I reinstall it
Any advice is appreceated,I am also going to request help from the NCRS web site some of those guys just never post over here,
A sincere thank you to the kind folks who did PM me with information
So I am going to have dish detergant as a lubrecant.
a bunch of dull edged putty knifes
All of my hardware ready to be installed.
some duct tape,
Some racheting binding straps.
Some twine.
a small rubber mallet,
Some surgical glove (hopefully to keep my hands from slipping)
My aim
Now when I removed my windsheild glass from the frame there was some dum dum in the corners,was this factory? why was it needed,where do I reinstall it
Any advice is appreceated,I am also going to request help from the NCRS web site some of those guys just never post over here,
A sincere thank you to the kind folks who did PM me with information