Here's a link to a trouble shooting guide. You should be able to find the issue using this. Click on "vacuum trouble" on the left side of the page.
Gary
1975 Corvette Convertible
Yes, you can get the door open without removing the panel. The picture below is looking down into the door right at the outside door handle. You will see a tab sticking out from the latch assembly (it's about a 1/4" wide). It's on the right side of the photo (sorry, I couldn't get any more light...
Check out this post. You need to pry open the buckle and remove it so you can get it through the slot. I did this on my 71' Vert and it work great.
:thumb
Gary
Reworking My Camaro Seat Belts To Pass Through - Page 2 - Corvette Forum
Does the other window work? If so, the fuse is OK. Next to check is the switch. You'll need to remove the side panel from the console. Use a volt meter to see if 12V is going to the motor. Not sure if there is a connector at the door that can be unplugged and probed for 12V. If so, that's the...
Corvette Fever had an article a few years back that listed Corvette shops that other Vette owners had good luck with. The list for NJ:
All About Alignment
Farmingdale NJ
Conte's Corvettes
Vineland, NJ
Corvette Paramedics
Mt Holly, NJ
Mr Driveshaft
Farmingdale, NJ
Hopefully one of these...
.
Are you trying to remove the whole dashpad or just the speedo/tech? If the speedo tech, loosen the 2 bolts that hold the steering column to the support bracket so it will drop down. After you remove the screws holding the speedo to the dashpad, it will pull forward.
Gary
Here's the 78' BW T-10 linkage. The pictures are pretty much how it goes on. I think the lever location may be different than the Muncie. Hope this helps.
Gary
I have the complete shifter and mounting brackets from my 78 (T-10) (went to a TKO-600) and can take what ever pictures you need. Do you need just the linkage or the brackets too?
Gary
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.