Does anyone have a judging sheet that I can use at our upcoming Corvette car show that you would share with me?
this is a wash and show event.
thanks,
Gary
I have a '69, 350 with factory A/C. On hot days the radiator coolent will flow out of the short hose attached to the rad overflow, not much, but some. I purchased a '69 overflow tank and straps, but couldn't install where the tank should go because of the A/C unit. Now i'm told that small...
Our Corvette Club-Boone Trail CC is sponsoring our annual Corvette Charity Car Show this Saturday- 25AUG12.
flyer.
http://www.boonetrailcc.com/Charity_Show.pdf
Thanks, Gary
I replaced the stock steering wheel in my ’69 with a ’82 for the smaller diameter wheel. I like the look, however I’m thinking about replacing again with a custom steering wheel. I have visited the CAC advertisers and didn’t find any to my liking. The Grant wheels can close, but I’m still...
I need to replace the heater core on my '69. Without removing the A/C parts in the engine compartment is there an easier way to do the replacement?
First I will try Stopleak to see if that does the trick.
Thanks,
Gary
Hi again,
The seats in my '69 covers were custom cloth and some of the holding wires(?) which ran from the material though the seat to the spring are loose causing bulging and wear on the seat cover. I’m going to replace the holding wires any instructions or help replacing these is welcome...
Hello,
I’m replacing the door locks on my ’69 and would appreciate advice on the installation.
I have replaced one and taking the lock out was not too bad, but putting in the new lock due to the tight area and new lock spring is difficult and took me hours. Am I missing an easier way to...
Question - I was told that on a 4 speed you can only start the car if the car in Neutral. My '69 will start sometimes in reverse and sometimes not. Does the lockout interlock need adjusting?
I purchased a 1969 Corvette from a out of state dealer in June. It has a 350 that has been modified for high performance. I dealer would not get me the past owners name and so I do not have contact to discuss the engine mod’s. It does run very well :)
My problem is, after a drive the engine...
Hello,
I just bought a 1969 Corvette Conv with no door key. The owner claimed that he didn't have one. What do I need to do to have a key made? do I have to take the door apart to remove the door lock. any help is greatly appreciated.
Gary
After driving, I can smell antifreeze, With my prevouis Vett this was the water pump failing and easy to check by drops of water on the floor under the pump and the rad fan had some back and forth play.
On this one no water drips from the pump, no fan on the block to tug on and water level...
August 29, 2009 our club is sponsoring a charity car show - Corvettes only. The charity is ALS.
Location: Bandanna's BBQ on Mid Rivers Mall Drive near Highway 94 in St. Peters, MO. $15 per car. Registration starts at 4pm.
I hope to see you there!
Link...
I received by NCCC package and within was the 50th anniversary patch. On the back side “Made in China” sticker was attached, I find this very disconcerting that our organization would, for cost reasons have the patches made outside of USA.
Just my $.02
Our club has an annual charity corvette car show and I was selected to coordinate the judging. The judging will be based of class of car, C1 – C6 stock of modified.
Does anyone have a judging form that they would share with me?
Gary
after releasing the emergency brake this week, the "Brake" dash light stays on. is there a switch on the handle mechanism that controls the dash light?
Over the weekend I saw, up close a red C6 that had Budweiser Daytona Shootout in large graphics on both sides and on the rear.
The owner purchased this at a dealer and said only two were made. I would say Its similar to a Indy pace car. 400+ hp, larger brakes, etc.
Does anyone know about...
Friends,
My 91 wouldn't start ( dead battery - sat too long ) so I jump started with no problem.
However
The digital readout - speedometer, gas gauge - doesn't read correctly or doesn't display at all.
The digital readout was working just fine before the dead battery. After I jumped...
Hi,
I'm insterested in buying crome 5 spoke wheels to replace my "sawblade" wheels. Questions:
Are crome Zo6 wheels the same as 5 spoke wheels?
What is the going cost for a set?
Is there a market for my sawblade wheels?
Will the 5 spoke bolt on with no problems?
Thanks
freinds,
My brother-in-laws birthday is coming up very soon...and I said I would get him a picture of a triple black 1967 convertable 427-400hp with side pipes, just like the one he had
I can't seem to find one. His BD is this Friday
Can someone please help me?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.